Construction Features:
– One-piece heavy duty, flame retardant ABS
polymer with white finish. Optional one-piece 18
gauge steel cover finished with electrostatically
applied, chip-resistant white epoxy finish (M),
or chrome plated satin finish (C).
– Permanently lubricated, maintenance-free,
brushless induction motor with automatic resetting
thermal protector. 1/12 HP, 3200 RPM.
– 100% solid state design eliminates
relay contact failures. Microprocessor controlled
infrared sensor turns dryer on when hands are
under the air outlet. Dryer turns off when hands
are removed. Override turns off in 80 seconds if
hands are not removed.
– Constructed of NiChrome
resistance wire
with automatic resetting thermostat.
Heating element operates in the black range for
maximum life.
– Two tamper resistant screws
secure cover to base.
GENERAL INFORMATION
Dryers should be placed at least 2 feet apart and at least 12” from
washbasin. Do not install dryer over washbasin. Automatic dryers should be at least 18” above any projection which may interfere with the operation of the automatic sensor.
Hand dryers require a dedicated circuit (max. 20 amp) and must be
properly grounded. One side of dryer should be mounted to stud. All
surface mount dryers are provided with conduit entrances for both
between wall and surface wiring.
Average traffic washroom..............1 dryer per 2 washbasins
Heavy traffic washroom..................1 dryer per washbasin
54” Bradley sink..............................4 dryers per sink
|
Click Here To Make Diagram Larger